2 NHTSA safety recall campaigns were
found for the 1995 Chevrolet C7.
NHTSA Recall 95V130000
Component:
EXTERIOR LIGHTING:BACK UP LIGHTS
Recall date:
1995-07-05
Defect Summary
THESE VEHICLES WERE ASSEMBLED WITH A TRANSMISSION REVERSE SIGNAL SWITCH THAT COULD LEAK CAUSING LOSS OF ELECTRICAL CONTACT WHEN THE TRANSMISSION IS IN REVERSE. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
Safety Risk
CONSEQUENCE OF NON-COMPLIANCE: THIS CONDITION CAN PREVENT THE BACKUP WARNING SYSTEM (LIGHTS AND AUDIBLE ALARMS) FROM OPERATING PROPERLY, INCREASING THE POTENTIAL FOR AN ACCIDENT.
Remedy
DEALERS WILL REPLACE THE REVERSE SIGNAL PRESSURE SWITCH.
NHTSA Recall 95V027000
Component:
SEATS
Recall date:
1995-02-16
Defect Summary
THE SEATS OF THESE VEHICLES CAN HAVE INCOMPLETE WELDED LEFT SIDE SEAT BACK FRAME EXTENDER ARM WELDS. VEHICLES WITH AFFECTED SEATS DO NOT COMPLY WITH FMVSS NO. 207, "SEATING SYSTEMS."
Safety Risk
COSEQUENCE OF NON-COMPLIANCE: THIS CONDITION CAN CAUSE THE SEAT TO COLLAPSE DURING A VEHICLE ACCIDENT AND WOULD NOT PROPERLY PROTECT THE OCCUPANT.
Remedy
DEALERS WILL INSPECT THE LEFT SIDE SEAT BACK EXTENDER ARMS OF THE SEATS FOR MISSING WELDS. WELDS SHOULD BE ON BOTH SIDES OF THE SEAT BACK EXTENDER ARM. IF A WELD IS MISSING, THE AFFECTED SEAT BACK FRAME ASSEMBLY(IES) WILL BE REPLACED.