7 NHTSA safety recall campaigns were found for the 1983 Ford F350.
Component: FUEL SYSTEM, DIESEL:STORAGE:TANK ASSEMBLY
Recall date: 1984-05-22
WATER SEPARATOR CANISTER MAY BE PUNCTURED IN A COLLISION. CRASH TESTS IN A 30 MPH FRONTAL COLLISION REVEALED FUEL LEAKAGE EXCEEDING THE MAXIMUM PERMITTED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY".
A PROTECTIVE SHIELD FOR THE CANISTER WILL BE INSTALLED WITHOUT CHARGE.
Component: FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS
Recall date: 1983-05-02
IN A COLLISION, BOLTS MAY DAMAGE OR PIERCE A FUEL LINE, CAUSING FUEL SPILLAGE. AFFECTED VEHICLES MAY NOT BE CAPABLE OF MEETING THE MINIMUM FUEL LEAKAGE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 301, "FUEL SYSTEM INTEGRITY".
THE DEALER WILL REPLACE THE EXISTING 2.18 INCH BOLTS IN THE LEFT FRONT FENDER APRON WITH ONE INCH LONG BOLTS AT NO CHARGE.
Component: POWER TRAIN:AUTOMATIC TRANSMISSION
Recall date: 1983-03-07
THE PARKING GEAR MAY NOT ENGAGE, EVEN THOUGH THE GEAR SHIFT LEVER IS PLACED IN THE "PARK" POSITION. THIS OCCURS IF THE LINKAGE INSIDE THE TRANSMISSION THAT ACTUATES THE PARK GEAR WAS IMPROPERLY MANUFACTURED. A PIN THAT RETAINS COMPONENTS ON A LINKAGE (ACTUATING) ROD COULD BREAK AND THE LINKAGE MAY NOT ENGAGE THE PARKING GEAR.
DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE PARKING PAWL ACTUATING ROD ASSEMBLY.
Component: STRUCTURE:FRAME AND MEMBERS:UNDERBODY SHIELDS
Recall date: 1982-12-13
FUEL SYSTEM ON THE SUSPECT VEHICLES MAY NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY". THESE VEHICLES WERE MANUFACTURED WITHOUT PROJECTILE FUEL TANK SHIELDS.
THE DEALER WILL INSPECT AND INSTALL A PROTECTIVE FUEL TANK SHIELD WITHOUT CHARGE TO OWNER.
Component: FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP
Recall date: 1982-12-13
SOME OF THE INVOLVED VEHICLES MAY HAVE A DIODE IN THE ELECTRICAL FUEL PUMP CIRCUIT THAT MAY SHORT DURING ENGINE STARTING DUE TO INADEQUATE CAPACITY TO WITHSTAND CURRENT DRAW. A SHORT CIRCUIT WOULD RESULT IN NORMAL ENGINE STARTING, BUT THE PUMP WILL NOT CONTINUE TO SUPPLY THE ENGINE WITH FUEL.
THE DEALER WILL REPLACE DEFECTIVE ELEMENT IN THE ELECTRICAL FUEL PUMP CIRCUIT WITH A NEW RELAY FEED WIRING ASSEMBLY WHICH CONTAINS A LARGER CAPACITY DIODE, FREE OF CHARGE.
Component: STRUCTURE:BODY:HOOD:HINGE AND ATTACHMENTS
Recall date: 1982-10-26
THE SPRINGS THAT ASSIST IN RAISING THE HOOD MAY DETACH FROM THE HOOD WITHOUT WARNING. THE HOOD CAN BE IN ANY POSITION WHEN THIS OCCURS.
THE DEALER WILL REPLACE THE HOOD LIFT ASSIST SPRING ASSEMBLIES WITH REVISED PARTS.
Component: POWER TRAIN:AXLE ASSEMBLY
Recall date: 1982-10-26
ON CERTAIN VEHICLES, THE LOCK WEDGES USED TO SECURE THE AXLE BEARING NUTS TO THE AXLE HOUSING MAY FALL OUT OF POSITION, ALLOWING THE NUT TO LOOSEN. THE NUT ON THE LEFT SIDE MAY FALL OFF, ALLOWING MOVEMENT OF THE AXLE SHAFT.
THE DEALER WILL REPLACE DEFECTIVE LOCK WEDGES WITH AN IMPROVED VERSION. WHEEL BEARINGS WILL BE INSPECTED AND ADJUSTED OR REPLACED, IF NECESSARY.
Recall applicability can depend on VIN and production details. Confirm your specific vehicle with the manufacturer or the official NHTSA VIN recall lookup.