3 NHTSA safety recall campaigns were found for the 1979 Ford Ltd Ii.
Component: SERVICE BRAKES, HYDRAULIC:PEDALS AND LINKAGES
Recall date: 1979-05-15
THE INVOLVED VEHICLES WERE PRODUCED WITH BRAKE PUSH-ROD TO BRAKE PEDAL RETAINING PINS WHICH WERE NOT HEAT-TREATED AS SPECIFIED. THIS COULD ALLOW THE BRAKE PEDAL TO BECOME DISENGAGED FROM THE PUSH-ROD.
DEALER WILL REPLACE THE SUSPECT BRAKE RETAINING PIN.
Component: SEATS:MID/REAR ASSEMBLY
Recall date: 1979-01-09
THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH INCORRECT WELD NUTS THAT ATTACH THE REAR PORTION OF THE FRONT OUTBOARD SEAT TRACK TO THE FLOOR PAN. THE INCORRECT NUTS HAVE AN OVERSIZE DIAMETER AND THREAD, AND UPON FRONT SEAT TRACK ANCHOR BOLT INSTALLATION, THE THREADS MAY HAVE BEEN STRIPPED.
THE DEALER WILL INSPECT AND, IF NECESSARY, REPAIR ANY STRIPPED WELD NUTS AND INSTALL LARGER SIZE BOLTS TO ANCHOR THE SEAT TRACK TO THE FLOOR AT NO COST TO OWNER.
Component: STEERING:GEAR BOX:SHAFT SECTOR
Recall date: 1978-12-21
THE STEERING GEARS ON THE INVOLVED VEHICLES MAY HAVE BEEN BUILT WITH IMPROPERLY MANUFACTURED SECTOR SHAFTS FROM WHICH THE THREADED PORTIONS OF THE SHAFTS MAY FRACTURE AND SEPARATE. SHOULD THE SECTOR SHAFT FRACTURE, THE PITMAN ARM MAY DISENGAGE FROM THE SPLINED PORTION OF THE SECTOR SHAFT.
THE DEALER WILL INSPECT AND, IF NECESSARY, REPLACE THE STEERING GEAR ASSEMBLY OR INSTALL A NEW SECTOR SHAFT IN THE STEERING GEAR ASSEMBLY.
Recall applicability can depend on VIN and production details. Confirm your specific vehicle with the manufacturer or the official NHTSA VIN recall lookup.