3 NHTSA safety recall campaigns were found for the 1984 Jeep Wagoneer.
Component: POWER TRAIN:DRIVELINE:DIFFERENTIAL UNIT
Recall date: 1984-04-09
A DEFECTIVE DIFFERENTIAL PINION SHAFT MAY EXIST WHICH CAN COME IN CONTACT WITH THE DRIVE PINION GEAR, CAUSING REAR WHEEL LOCK-UP.
PINION SHAFT AND CLIPS, AND POSSIBLY THE PINION GEAR, WILL BE REPLACED WITHOUT CHARGE.
Component: STEERING
Recall date: 1984-03-16
THESE VEHICLES MAY HAVE BOLTS IN THE STEERING SYSTEM THAT WERE NOT PROPERLY TIGHTENED.
THE ADJUSTING TUBE CLAMP BOLT AND THE STEERING GEAR ATTACHING BOLT TORQUE WILL BE TESTED. THE BOLTS WILL BE TIGHTENED AND THE FRONT WHEEL TOE SETTING ADJUSTED IF NECESSARY AND AT NO COST TO OWNER.
Component: POWER TRAIN:AXLE ASSEMBLY:BANJO HOUSING
Recall date: 1984-03-07
IMPROPER ASSEMBLY OF THE REAR AXLE MAY CAUSE AXLE BEARING FAILURE AND COULD RESULT IN THE SEPARATION OF A REAR AXLE AND WHEEL.
THE DIFFERENTIAL AND AXLES WILL BE INSPECTED FOR THE DEFECT AND REPLACED WITHOUT CHARGE, IF NECESSARY.
Recall applicability can depend on VIN and production details. Confirm your specific vehicle with the manufacturer or the official NHTSA VIN recall lookup.